3DAlienWorlds BLOG

Printing the castle corner tower

Whoa! This is only a two-level corner tower for a castle board, but it's quite a biggie!!! Just imagine how GIGANTIC the full 5 level castle will be!!

Here are some pics of the whole printed castle corner tower, which will be getting a release later this week....

£ View from ground level - even at only two levels, this corner tower would be quite imposing to an attacker!



£ So if you're feeling like your lordly coffers are running a bit low, why not try this economy single-level version? ¤£



£ The corner tower can be used on its own, at ground level, if you prefer? But I reckon it looks best perched on some ancient castle walls, terrifying your foes!



£ If you're printing the second level of the corner tower, you'll need to print this staircase for the inside, too. As you can see, the interior is fully textured with authentic details - murder holes in the floor, arrow slits, a working hinged door, and optional shutters (plus their super hi-tech "sticks").



£ As you can see, the second level of the tower matches up with the staircase below, although the steps are very steep and very narrow - just like the real thing!!



£ Set contents - two versions of the bigger roof, two levels and a corner walls section - designed to link up with the other castle walls set perfectly.



£ Time for some 360 degree pics...... here's the view of the tower as seen from outside the walls. Note the overhanging sections designed for shooting down on attackers.



£ The left side will be inside the castle walls, so I didn't attach any shutters to that window.

£ The tower as seen from inside the castle walls. Looks a bit friendlier from this angle, yes?

This tower will be hitting my paint desk tonight, and we should have a painting guide and some finished photos for you very shortly! Watch this space!!

Name
Comments
Enter Code