3DAlienWorlds BLOG

Necrontyr Obelisk set complete!

This set of Necron-themed obelisks just grew and GREW! The final set includes 11 separate pieces, in 3 different sizes each - to fit the lower, middle and upper levels of each monument.



Here's a few sample combinations for you...



Each level is approximately 120mm tall, and the largest 3-level monuments can be extended further using the bases and obelisk tops to over 50cm!



There are two versions of bases: inverted plain monument bases, and the slightly larger footprint of the vertical vents base (pictured above). The vented base has 4 cut-outs on each side, and can be fitted with an LED tea-light inside.



There are also 5 versions of top design. There is a plain flat top, a plain pyramid, another pyramid with necron-inspired engravings, the stand-up Necron symbol (pictured above) on a vented flat top, and finally ..... the classis power crystal with 4 support pillars on another vented top (pictured below). PHEW!



The crystal could even be printed in clear PLA filament to enable uplighting from the vent to make it glow.



While most of the body sections are solid, they can all be fitted with LED lights, and they all contain internal supports for adding lights at different levels. One of the body designs (pictured above) is the classic Necron-inspired symbol with wall cut-outs, so the obelisk can be lit with an eery glow on any level.

Next up will be a handy little gaming tool! Watch this space...

Name
Comments
Enter Code